W75 no water

[tdrocket]

I Have a W75 that was spinning for hours on the rinse cylcle and was very hot by the time i unplugged it. After letting it cool down i tried to run it thru a full cycle and the timer "wheel" just spun very slowly until it was at the end of the cycle. No water ever entered the machine the entire time. My question..... Is the timer wheel spinning because it is not sensing any water, and does this sound like a valve that lets the water in went bad. Thanks for the help.
Tim

[Phillip]

The machine will continue to run until the washer fills with water. I suspect a clogged inlet water valve. Shut the machine down and shut off the water, remove fill hose to check filter at back. Clean it if its dirty, if not, open the top lid to access the water valves. Inside the valve is a blue diaphragm that may be clogged. This diaphragm is under the electrical solenoid. There is a tool that is strapped to your hoses that allows you to open the cover for the diaphragm. Be careful not to drop the spring or plunger. Good luck