PDA

View Full Version : Ram Ingn' failed after 3 weeks to the man that installed it.


Tini Bubbles
01-21-2003, 12:12 PM
I can't belive this, I did my own cloths yesterday @ the Mat.
Toss them in my dryer that I installed the Ram Kit in with a smile.
throw in a $1.00 and walk away hereing the spark light the burner. I come back later thinking they will be dry, NO!!!!!!!!!!!.
Damn cloths where wet. I toss in anouther dryer, check Ram kit and it worked just fine, and has been for at least 20 more spins.
I don't know if this will be a good product to change over to.
For my first test run of only 3 weeks I give it a rateing from 1 to 10. I will give it a 5. Tini 2 cents

David
01-21-2003, 01:00 PM
In the installation instructions, it says to place the ignitor in the coolest part of the burner. Forget this, put it right over the burner.

I had the same problem with intermittent flames. After I moved the ignitor over, no more problems.

Tini Bubbles
01-22-2003, 11:56 AM
David, thanks for the reply.
My spark Ing' is over at least two of the first set of holes in the row in the burner. I will try to move closer and see.
I have it 3/8 from burner, any closer I noticed it grounding on the burner, not the ground rod for sparky. So I moved it up to 3/8 from top of burner and that problem was handled. I will move sparky over at least 3 holes in the row and try that.
Tini 2 cents

pete f
01-22-2003, 05:18 PM
I changed over a group of dryers years ago from glow bar to rams, and it so happned one of the rams was defective. It was actually the sparker, it is a sensor for the heat also, so if the heat does not come on quick it will shut the coil off. Keep it close to the burners as others have said.

homchz
01-30-2003, 05:07 PM
I have heard that the synetek kits which are an almost direct replacement for the Rams are a bit better, they try to ignite 3 time before shutting down. Ram's only once.
By almost direct, the only difference I have seen is the bolt pattern for the casing.

Lar Hylobates
01-30-2003, 09:49 PM
Tini...you need a wife.

Tini Bubbles
01-31-2003, 11:36 AM
Divorced once, two children from two differant women.
I have been with over 107 women now in my day.
You could say I have had enough!!!!!!!.
Tini has had enough Poon Tang. My resent girl is 29 years old and great. I am 41 and still stiff. ha, Ha. Tough luck eH!.
Tini works to much now to think of a woman, just my children are my priority for the future. The Women in my life come last. SORRY
Tini 2 cents :D

Lar Hylobates
02-01-2003, 12:48 AM
Guess you like to do your own laundry. Honestly, I was just glad to see noone was still babbling on about some ram ignitor. Who cares, I've got about 20 of them lying in a box in my garage and have NEVER replaced one in two years.

Oh, there I go babbling.