PDA

View Full Version : Milnor

Anonymous
06-30-2006, 06:32 PM
Has anyone seen the new Milnor Visionex 20lb or 40lb washers? What do you think?
Silent Roo
07-01-2006, 10:28 AM
Well I typicaly tell people to wait at least a year on new equipment and see how it runs in the real world.

This might be one I would consider out of the gate. I have seen them they look and run sharp. Milnor has always gone the extra mile on quality. They have OPL stuff that runs 15 hours a day for 20 years. It is hard to argue their quality.
soapman
07-01-2006, 08:01 PM
I'm interested in the 20lb washer. Is this high extract? Has anyone used this machine?
Ken
07-01-2006, 09:01 PM
NO,it is not high extract,it is under 100G,check other factories washer's G force.The higher G force,the better extract.
I will not buy the first 1,2 years model anyway.Milner has some overkill control system in some of their washers,don't know much about this model.
soapman
07-02-2006, 03:10 PM
Ken
What do you mean by overkill control?
Ken
07-02-2006, 03:53 PM
I opened a few Milner 35# control panel,it had so many wires,relays......you have to see to know what I mean.Milner build great machine,some people really like them,not a lot people use them in coin op business,a lot OPL buy them.
I suggest you take a look the machine,inside,outside,inside control panel then decide what to buy.
The wizard
07-02-2006, 10:54 PM
Based on my information the newer small amchines are built overseas if not China. They are doing this to be compeitive with others in the low end market. Their good 55 lb machine " american make" which is a work horse that will last for years is now too expensive for the coin market. Too much compeitition and customers who look at cost vice dependibility and longevitivity. Are the new ones proven not at this point! They even had delays in production and placing them on the market. I saw one at the clean show and it was different from anything they have produced. I feel its is being made by some one else for them I just cannot place the manufacturer yet. The star door handle I have seen before.
Anonymous
07-03-2006, 10:19 AM
i have been to the Milnor factory. it is big and they make everything in New Orl.
The wizard
07-06-2006, 12:55 AM
i have been to the Milnor factory. it is big and they make everything in New Orl.

You actually saw the new visonex machine being built from scratch.
Anonymous
07-06-2006, 02:31 PM
i visited there a few years ago, so the answer is no.
The wizard
07-07-2006, 12:21 AM
The production label should state the country of manufactuer or it may hide it as final assembly. etc.