PDA

View Full Version : Gas Valves for JT 32DG

POLLWOOD
07-22-2003, 08:16 PM
The model # 430650. Does anyone know where to get parts for these. I have been combining old units to make refurbished ones. These valves are very expensive. It is usually the high fire "pin" that breaks.
thks
MSKLAUNDRY.
07-22-2003, 08:48 PM
One of this sites sponsers, Laundryparts.com has it for $99
, is that too much?

http://www.laundryparts.com/dry_cmstack_sqhue.htm

Tell them you saw their link on Coinwash.com
POLLWOOD
07-22-2003, 09:09 PM
last ime I checked, they were more than that! Might have to order some

thks
Anonymous
07-24-2003, 12:41 AM
Why change the whole valve when you can change the coils?
MSKLAUNDRY.
07-24-2003, 06:54 AM
I was saying the same thing myself. He saying something about a pin breaking. I assume the pin he is talking about is the "plunger" in the center.
POLLWOOD
07-24-2003, 10:12 AM
I have yet to have coils fail. It is always one of the 3 plungers, which are not universal, that fail. If there is someone who isn't comfortable rebuilding their own valves, I would gladly accept old valves.
The first plunger from the gas inlet (on top) is a main valve that shuts off the gas completely.
The second plunger from the inlet (on top) is the low fire.
The third plunger from the inlet (on the end) is the high fire.

off to see if at35 bearing is rebuilt
Anonymous
07-24-2003, 07:26 PM
How does the plunger go bad?
POLLWOOD
07-24-2003, 09:02 PM
The shaft of the plunger/pin breaks. Can't be repaired, by me anyway! Way too fine for this old plumber.